With default config and `EEPROM_SETTINGS`, saves over 200 bytes of PROGMEM.

Fix #12015

Fix #12004

CNC GCode dialect compatibility improvements

* Support new TMC library and 32-bit Archim board

- Added IS_MCU flag
  - When IS_MCU flag is 1, AVR compiler will be used
  - When IS_MCU flag is 0, ARM compiler will be used
- Added support for new TMC library
- Added support for a 32-bit Archim board, which could probably be used as a basis for other 32-bit boards.

[2.0.x] Add support for USB thumbdrives/flashdrives

Co-Authored-By: marcio-ao <marcio@alephobjects.com>

- Use a comma for decimals just in one message has not been a good idea.
- Full comments translation

Prescalers aren't calculated for the given target frequency.
Stepper timer should run at 2 Mhz and temperature timer at 72 Khz.

And set EEPROM_OFFSET to 0, since the historical 100 skipped bytes are never used.