- Use `TEST(dm,axis)` to determine directions instead of doing comparisons.
- Remove recomputation of `millimeters` and `delta_mm` since backlash compensation should not affect the distance over which material is extruded.

(Exactly matching the Azteeg X5 MINI Wifi)

* Add support for MKS Robin TFT display

- Add support for MKS Robin TFT display and encoder for MKS Robin board.
- Generic 128x64 UI with x2 upscale is used (for now).
- Tested on MKS Robin TFT V2.0 with ST7789V controller.

Move `watchdog_reset` from `.h` to `.cpp` to eliminate the need to include `MarlinConfig.h` in a HAL-related file.

* Make ExtUI respect MAXTEMP limits
  - Temperatures are now clamped by MAXTEMP limits rather than arbitrary values.
* Speed up USB init, add status
  - Speed up USB initialization
  - Show status message if init failed
* Enable status messages for EXTENSIBLE_UI
* Adjust max limit to MAX_TEMP - 15
* Misc. tweaks to formatting, const, etc.

Followup to #12770

On some T-Rex 2+ machines the previous max step rate could lose steps....