- Nov 21, 2019
-
-
Scott Lahteine authored
-
Scott Lahteine authored
-
Jason Smith authored
-
Jason Smith authored
-
Bob authored
-
Scott Lahteine authored
-
Scott Lahteine authored
-
- Nov 20, 2019
-
-
Roman Moravčík authored
-
BigTreeTech authored
-
Scott Lahteine authored
-
InsanityAutomation authored
-
thisiskeithb authored
-
Daniel Negut authored
-
InsanityAutomation authored
-
Giuliano Zaro authored
-
Jason Smith authored
-
Evgeny-SPB authored
-
Jason Smith authored
-
Giuliano Zaro authored
-
TheAssassin authored
-
InsanityAutomation authored
-
Luu Lac authored
-
swilkens authored
-
- Nov 18, 2019
-
-
Scott Lahteine authored
-
- Nov 17, 2019
-
-
Scott Lahteine authored
-
- Nov 16, 2019
-
-
Robby Candra authored
-
- Nov 15, 2019
-
-
Scott Lahteine authored
-
Roxy-3D authored
If the IDEX mode was previously set (via GCode or the LCD Panel) to a duplication mode... It was lost after a G28 due to this redundant setting of 'extruder_duplication_enabled'. It is very important to the various use cases of IDEX machines that extruder_duplication_enabled is preserved across a G28. The reason is this allows a person to use the LCD Panel to put the machine into a duplication mode, and then send a 'normal' part file to the printer and get two parts out of the process.
-
thisiskeithb authored
-
Scott Lahteine authored
-
Scott Lahteine authored
-
- Nov 14, 2019
-
-
Lino Barreca authored
-
Lino Barreca authored
-
Scott Lahteine authored
-
Tanguy Pruvot authored
-
Scott Lahteine authored
-
- Nov 13, 2019
-
-
Scott Lahteine authored
-
Scott Lahteine authored
-
Scott Lahteine authored
-
Robby Candra authored
-
