Messages in gcode files like “M117 Printing…” were not being cleared on
Stop Print.

Adding Support for Toshiba Stepper Drivers

Tosh stepper drivers need to be driven slower, so the stepper code
was interleaved to separate the pin HIGH from the pin LOW. This adds
enough instructions to make it work, without needing nops.

Tosh stepper drivers need to be driven slower, so the stepper code
was interleaved to separate the pin HIGH from the pin LOW. This adds
enough instructions to make it work, without needing nops.

Messages in gcode files like “M117 Printing…” were not being cleared on
Stop Print.

Messages in gcode files like “M117 Printing…” were not being cleared on
Stop Print.

M0/M1 Message Fix

M0-M1 Enhancements

Updated a bit of spanish language

The welcome message is more appropriate than “resuming print” if
nothing is printing.

Allow M0 and M1 to include a message string. Ignore clicks on “Wait for
user” so that the Info Screen stays up.

The welcome message is more appropriate than “resuming print” if
nothing is printing.

Allow M0 and M1 to include a message string. Ignore clicks on “Wait for
user” so that the Info Screen stays up.

Add Travis CI config to build Marlin firmware.

Changed graphic LCD info screen to match the set # of extruders

Here comes a compile-time operation to match the extruder symbols on the
info screen to the set number of extruders in configuration.h.
When only one extruder is selected, the "1" on the symbol will not be
displayed.

Comment out the FILAMENT_SENSOR define by default in config.

Commented out the FILAMENT_SENSOR define so that it is not enabled by
default.  Code does not work on all hardware variants.

Sync up to Marlin

Updated example configurations for Delta printers

Fixed typo.

Support for a filament diameter sensor

Signed-off-by: Christian Inci <chris.pcguy.inci@gmail.com>

Fix "add_homeing" to "add_homing" to match changes

Update line 627 ,wrong number on thermistortables