remove fuses note, MCU will always run at default frequency (1MHz)
This commit is contained in:
parent
6508e45b49
commit
9b962e1fa0
1 changed files with 3 additions and 8 deletions
11
Readme.md
11
Readme.md
|
|
@ -17,14 +17,9 @@ The I2C Messages are always 2 Bytes long. The fist contains the command and the
|
|||
| 0x05 | 0x00 | Set the long delay in seconds ( The value is the delay ) |
|
||||
|
||||
## MCU Install
|
||||
To programm the MCU you need a ISP Programmer like the USBasp. You can either use PlatformIO to compile the firmware yourself or use avrdude ( or avrdudess for a GUI version ) to upload the precompile firmware from the CI assets. The precompiled firmware is always for attiny25, but you can use it for attiny45 and attiny85 too. After flashing please check the fuse settings. The default fuse settings are:
|
||||
| Fuse | Value |
|
||||
|------|-------|
|
||||
| Low | 0xE2 |
|
||||
| High | 0xDF |
|
||||
| Extended | 0xFF |
|
||||
To programm the MCU you need a ISP Programmer like the USBasp. You can either use PlatformIO to compile the firmware yourself or use avrdude ( or avrdudess for a GUI version ) to upload the precompile firmware from the CI assets. The precompiled firmware is always for attiny25, but you can use it for attiny45 and attiny85 too.
|
||||
|
||||
For initial flashing with the USBasp it is required to short the J3 Header on the USBasp.
|
||||
For flashing with the USBasp it is required to short the J3 Header on the USBasp.
|
||||
|
||||
## Connections
|
||||
The PCB contains two RJ11 sockets. One is the input and the other one the output. It doesn't matter which one is which. Via the RJ11 power and I2C is transported. The connector CN1 is for SPI flashing the MCU. On the right you have the pins for connecting the reset and the power button of the computer.
|
||||
The PCB contains two RJ11 sockets. One is the input and the other one the output. It doesn't matter which one is which. Via the RJ11 power and I2C is transported. The connector CN1 is for SPI flashing the MCU. On the right you have the pins for connecting the reset and the power button of the computer.
|
||||
|
|
|
|||
Loading…
Add table
Add a link
Reference in a new issue