From e2ff536b0316bd701ce5712fdbd7e3a69efdffff Mon Sep 17 00:00:00 2001
From: Alexander Kasimir <alexander@kasimir.at>
Date: Wed, 22 May 2013 16:02:03 +0300
Subject: [PATCH] Fixed typo in Comment

---
 Marlin/Configuration.h | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h
index ca72ae2b57..923d0ef04d 100644
--- a/Marlin/Configuration.h
+++ b/Marlin/Configuration.h
@@ -152,7 +152,7 @@
 // Bed Temperature Control
 // Select PID or bang-bang with PIDTEMPBED.  If bang-bang, BED_LIMIT_SWITCHING will enable hysteresis
 //
-// uncomment this to enable PID on the bed.   It uses the same ferquency PWM as the extruder.
+// uncomment this to enable PID on the bed.   It uses the same frequency PWM as the extruder.
 // If your PID_dT above is the default, and correct for your hardware/configuration, that means 7.689Hz,
 // which is fine for driving a square wave into a resistive load and does not significantly impact you FET heating.
 // This also works fine on a Fotek SSR-10DA Solid State Relay into a 250W heater.
-- 
GitLab