diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h
index 5838943898a99fc724535a0e735668a2000dc4e3..b7f8f4f1df414e9470343388cb686647ebe2b579 100644
--- a/Marlin/Configuration.h
+++ b/Marlin/Configuration.h
@@ -478,14 +478,14 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l
 
   #else  // !AUTO_BED_LEVELING_GRID
 
-      // Arbitrary points to probe.
-      // A simple cross-product is used to estimate the plane of the bed.
-      #define ABL_PROBE_PT_1_X 15
-      #define ABL_PROBE_PT_1_Y 180
-      #define ABL_PROBE_PT_2_X 15
-      #define ABL_PROBE_PT_2_Y 20
-      #define ABL_PROBE_PT_3_X 170
-      #define ABL_PROBE_PT_3_Y 20
+    // Arbitrary points to probe.
+    // A simple cross-product is used to estimate the plane of the bed.
+    #define ABL_PROBE_PT_1_X 15
+    #define ABL_PROBE_PT_1_Y 180
+    #define ABL_PROBE_PT_2_X 15
+    #define ABL_PROBE_PT_2_Y 20
+    #define ABL_PROBE_PT_3_X 170
+    #define ABL_PROBE_PT_3_Y 20
 
   #endif // AUTO_BED_LEVELING_GRID
 
@@ -504,8 +504,8 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l
   #define Z_RAISE_BETWEEN_PROBINGS 5  // How much the Z axis will be raised when traveling from between next probing points.
   #define Z_RAISE_AFTER_PROBING 15    // How much the Z axis will be raised after the last probing point.
 
-//#define Z_PROBE_END_SCRIPT "G1 Z10 F12000\nG1 X15 Y330\nG1 Z0.5\nG1 Z10" // These commands will be executed in the end of G29 routine.
-                                                                            // Useful to retract a deployable Z probe.
+  //#define Z_PROBE_END_SCRIPT "G1 Z10 F12000\nG1 X15 Y330\nG1 Z0.5\nG1 Z10" // These commands will be executed in the end of G29 routine.
+                                                                             // Useful to retract a deployable Z probe.
 
   //#define Z_PROBE_SLED // Turn on if you have a Z probe mounted on a sled like those designed by Charles Bell.
   //#define SLED_DOCKING_OFFSET 5 // The extra distance the X axis must travel to pickup the sled. 0 should be fine but you can push it further if you'd like.